Kali 2.0/John the Ripper: Difference between revisions
From charlesreid1
(Created page with "=Problems= Started running into problems immediately, trying to dump generated passwords to stdout using John. Illegal inputs, or some baloney. In any case, my workaround wa...") |
|||
| Line 12: | Line 12: | ||
$ unzip JohnTheRipper-jumbo-1.8.zip | $ unzip JohnTheRipper-jumbo-1.8.zip | ||
</pre> | </pre> | ||
==Install OpenSSL Development Libs== | |||
Now install OpenSSL development headers before we install John the Ripper: | Now install OpenSSL development headers before we install John the Ripper: | ||
| Line 17: | Line 19: | ||
<pre> | <pre> | ||
$ apt-get install libssl-dev | $ apt-get install libssl-dev | ||
</pre> | |||
==Configure and Make John== | |||
Now we can run configure and make: | |||
<pre> | |||
$ ./configure | |||
$ make clean && make -s | |||
</pre> | </pre> | ||
Revision as of 04:16, 19 August 2015
Problems
Started running into problems immediately, trying to dump generated passwords to stdout using John. Illegal inputs, or some baloney.
In any case, my workaround was to install a different John from the Kali 2.0 system John.
Install John
I downloaded John jumbo-1.8. There are lots of versions so make sure you get the latest jumbo.
$ unzip JohnTheRipper-jumbo-1.8.zip
Install OpenSSL Development Libs
Now install OpenSSL development headers before we install John the Ripper:
$ apt-get install libssl-dev
Configure and Make John
Now we can run configure and make:
$ ./configure $ make clean && make -s