Kali 2.0/John the Ripper: Difference between revisions
From charlesreid1
No edit summary |
|||
| Line 28: | Line 28: | ||
$ ./configure | $ ./configure | ||
$ make clean && make -s | $ make clean && make -s | ||
</pre> | |||
=Problem Solved= | |||
Check out the before and after - the system john, and my john: | |||
<pre> | |||
$ john -wordlist:/root/codes/john/rockyou10.lst -stdout | |||
Illegal instruction | |||
$ ./john -wordlist:/root/codes/john/rockyou10.lst -stdout | head -n 10 | |||
Press 'q' or Ctrl-C to abort, almost any other key for status | |||
92p 0:00:00:00 100.00% (2015-08-18 21:22) 766.6p/s junior | |||
123456 | |||
12345 | |||
123456789 | |||
password | |||
iloveyou | |||
princess | |||
1234567 | |||
12345678 | |||
abc123 | |||
nicole | |||
</pre> | </pre> | ||
Revision as of 04:23, 19 August 2015
Problems
Started running into problems immediately, trying to dump generated passwords to stdout using John. Illegal inputs, or some baloney.
In any case, my workaround was to install a different John from the Kali 2.0 system John.
Install John
I downloaded John jumbo-1.8. There are lots of versions so make sure you get the latest jumbo.
$ unzip JohnTheRipper-jumbo-1.8.zip
Install OpenSSL Development Libs
Now install OpenSSL development headers before we install John the Ripper:
$ apt-get install libssl-dev
Configure and Make John
Now we can run configure and make:
$ ./configure $ make clean && make -s
Problem Solved
Check out the before and after - the system john, and my john:
$ john -wordlist:/root/codes/john/rockyou10.lst -stdout Illegal instruction $ ./john -wordlist:/root/codes/john/rockyou10.lst -stdout | head -n 10 Press 'q' or Ctrl-C to abort, almost any other key for status 92p 0:00:00:00 100.00% (2015-08-18 21:22) 766.6p/s junior 123456 12345 123456789 password iloveyou princess 1234567 12345678 abc123 nicole